How to Install Reverse Osmosis

How to Install Reverse Osmosis 2Although the idea of how to install reverse osmosis may sound difficult for some, rest assured that something like this can be done in just a couple of hours. After the installation of the purifier you can enjoy a supply of purified water right away.

The Benefits

For those who buy plenty of filtered or bottled water regularly, most experts would agree that a reverse osmosis investment could be a investment. This equipment is capable of producing around 10 gallons of clean water and each system costs around $150-$300.

How to Install Reverse Osmosis
Here’s a detailed guide on how to install reverse osmosis even without professional help.

Step 1: Mounting the Water Supply Feed

Begin by hanging the filtration assembly on the side or back of the sink This could also be in the basement near the outlet or at the height given in the instructions. After that, turn off both hot and cold water shut offs and proceed to installing the saddle or tee valved that comes together with the unit.

The water-supply line should be snipped off so that it would stay on top of the base and there aren’t any risks that it would get kind. Don’t forget to secure the plastic tubing all over the supply valve.

In order to remove the excess water tubing, the water supply, together with the waste lines of the faucet should be shortened. However, ensure that the cut won’t go beyond the waste line, together with the faucet base. While the fittings should be securely attached

The faucet should be fastened up to the sink, and don’t forget to install the adapter located beneath the sink basket. Trim the waste link so that it will flow smoothly without any loops.

Position the storage tank properly and install the water line. Follow the manufacturer’s instruction when installing the system.

Recharging a Reverse Osmosis Filter Tank

If the system doesn’t produce enough water, then it’s ideal to change the membrane and filters to see if this will fix the problem. A reverse-osmosis tank uses a tire valve-style that could lose air after a period of time. The moment the pressure goes down, the bladder won’t be able to produce as much water anymore.

Flushing the System and Checking Operation

In order to check if the reverse-osmosis system has been installed properly, you have to flip the faucet lever up and this would keep the faucet on. This should be done so that the tank would be able to completely drain all the water. Then, close the faucet and reinspect the system once again to see if there are any leaks. Allow the system to produce water for around 4 hours, this would keep the bladder tank full. Open the faucet again and empty it.

The installation of reverse-osmosis system doesn’t have to be a difficult task. Just follow the guideline discussed above and you’ll be able to install your system in no time.

Leave a Reply